Created by W.Langdon from gp-bibliography.bib Revision:1.4782
This work modifies symbolic circuit analysis in Matlab (MSCAM) tool which uses Netlist from PSpice or from simulation to generate matrices. These matrices are used for optimisation or to compute circuit parameters. The tool is modified to handle both active and passive elements such as inductors, resistors, capacitors, transistors and op-amps. The transistors are transformed into SSA and opamp use the SSA that is easy to implement in programming. Results are presented to illustrate the potential of the algorithm. Results are compared to PSpice simulation and the approach handled larger matrices dimensions compared to that of existing symbolic circuit analysis in Matlab tool (SCAM). The SCAM formed matrices by adding additional rows and columns due to how the algorithm was developed which takes more computer resources and limit its performance. Next to this, this work attempts to reduce component count in high-pass, low-pass, and all-pass active filters. Also, it uses a lower order filter to realise same results as higher order filter regarding frequency response curve. The optimisers applied are GA, PSO (the best two methods among them) and Nelder-Mead (the worst method) are used subsequently for the filters optimisation. The filters are converted into their SSA while nodal analysis is applied to transform the circuit to matrices form. Highpass, lowpass, and allpass active filters results are presented to demonstrate the effectiveness of the technique. Results presented have shown that with a computer code, a lower order opamp filter can be applied to realise the same results as that of a higher order one. Furthermore, PSO can realise the best results regarding frequency response for the three results, followed by GA whereas Nelder-Mead has the worst results.
Furthermore, this research introduced genetic folding (GF), MSCAM, and automatically simulated Netlist into existing genetic programming (GP), which is a new contribution in this work, which enhances the development of independent Matlab toolbox for the evolution of passive and active filter circuits. The active filter circuit evolution especially when operational amplifier is involved as a component is of it first kind in circuit evolution. In the work, only one software package is used instead of combining PSpice and Matlab in electronic circuit simulation. This saves the elapsed time for moving the simulation between the two platforms and reduces the cost of subscription. The evolving circuit from GP using Matlab simulation is automatically transformed into a symbolic Netlist also by Matlab simulation. The Netlist is fed into MSCAM; where MSCAM uses it to generate matrices for the simulation. The matrices enhance frequency response analysis of low-pass, high-pass, band-pass, band-stop of active and passive filter circuits. After the circuit evolution using the developed GP, PSO is then applied to optimise some of the circuits. The algorithm is tested with twelve different circuits (five examples of the active filter, four examples of passive filter circuits and three examples of transistor amplifier circuits) and the results presented have shown that the algorithm is efficient regarding design.",
supervisor: T. Kalganova",
Genetic Programming entries for Ogri James Ushie